Cabletron Systems CyberSWITCH CSX5500 Quick Start Manual

Also see for CyberSWITCH 5500: User guide Manual

Contents

Central Site Remote Access Switch 27C ONNECTIVITYConnecting a Central Site Product to a CSX100 via PPP4. Under Security, select Device Level Databases, select On-node Device Entries, then add a devicewhere the Device Name (Remote) must match the system name on Remote. When you add thedevice you must then enter the following information:a. Under ISDN Information select ISDN Line Protocol, then select PPP.b. Optional: If you wish to dial out to Remote, under ISDN Information you must enter a dialout number (13135552222) and a base data rate (64Kb).c. Under Authentication you must:• Change CHAP Secret so that it matches Remote’s System secret (Remote_S).• Optional: Configure Calling Line Ids (if Calling Line Id security was enabled).d. Under IPX Information:• Enable IPX.• Enable Make Calls for IPX data.• Select RIP/SAP as the Routing Protocol.5. Return to the Options menu, select IPX Routing, then select IPX Static Routes. You will have toconfigure a static route to the 0000FACE LAN. When you configure a static route to a site youmust enter the name of the device or node address of the next hop device, Remote in this case.C ONFIGURATION FOR SITE “REMOTE”The configuration on Remote to allow IPX Routing to Central using PPP is as follows:1. Start QuickSET and select Custom.2. Configure the CSX100 system information.a. Accept the Local Ethernet IP Address. Click Next.b. Set your CyberSWITCH Name (Remote) and System Password (Remote_S).c. Select your switch type.d. Enter the directory number for the CSX100 (13135552222). Click Next.e. Enable IPX Routing by clicking in the box.f. Set the External Ethernet Network Number (0000FACE). Click Next.3. Define Central as a remote connection.a. Click Add Remote, enter Central, and click OK.b. Set the password. Click Remote’s Password and enter Central_S twice for confirmation.c. Define Central’s phone settings. Enter 13135551111.d. Optional: Define Caller ID Numbers if Caller ID Security was enabled. Click Next.e. Configure a service entry. Click Add Route and then SAP Table.• Select File Server.• Enter FILESER1 for the Server Name.• Set the Internal Network Number (43210900).• Set the Ticks (3).• Accept the Socket Number (0451).• Set the Hop Count (2).• Set the Node address (000000000001).• Accept the External WAN Network Number (00000000).• Click OK.4. Click Save.