Chapter 7: General Configuration Using Local ManagementHSIM-W6 User’s Guide 1293. Press ENTER to set the system time.4. Use the arrow keys to highlight the SAVE command field at the bottom of the screen and pressENTER. If the time entered was a valid format, the Event Message field at the top of the screendisplays “SAVED OK”. If the entry was not valid, Local Management does not alter the currentvalue and refreshes the System Time field with the previous value.Setting the Host IP AddressTo set the host (the HSIM-W6) IP address, perform the following steps:1. Use the arrow keys to highlight the Host IP Address field.2. Enter the IP address using Decimal Dotted Notation (DDN) format.For example: 134.141.25.173. Press ENTER. If the IP address entered was a valid format, the cursor returns to the beginningof the Host IP Address field. If the entry was not valid, the Event Message field displays“INVALID IP ADDRESS OR FORMAT ENTERED”. Local Management does not alter thecurrent value and refreshes the Host IP Address field with the previous value.4. Use the arrow keys to highlight the SAVE command field.5. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.Setting the Subnet MaskSubnets are logical divisions of the network. To change the subnet mask from its default value,perform the following steps:1. Use the arrow keys to highlight the Subnet Mask field.NOTEWhen entering the time in the system time field, you do not need to add separatorsbetween hours, minutes, and seconds, as long as each entry uses two decimalnumbers. For example, to set the time to 6:45 a.m., type “064500” in the System Timefield.
