Chapter 7: General Configuration Using Local Management134HSIM-W6 User’s GuideEnable Traps — Use this field to enable the transmission of SNMP traps to the managementworkstation.Setting the SNMP Trap DestinationEach management workstation designated to receive SNMP traps from the HSIM-W6 must have avalid IP address and community name. To set and enable SNMP trap destination, perform thefollowing steps:1. Use the arrow keys to highlight the Trap Destination field that you want to modify.2. Type the IP address of the management workstation designated to receive SNMP traps from theHSIM-W6. This address must be entered in DDN format.For example: 134.141.25.173. Press ENTER. If the IP address entered was a valid format, the cursor returns to the beginningof the Trap Destination IP address field. If the entry was not valid, the Event Message fielddisplays “INVALID IP ADDRESS OR FORMAT ENTERED”. Local Management does notalter the current value and refreshes the Trap Destination IP address field with the previousvalue.4. Use the arrow keys to highlight the Trap Community Name field (on the same row as the TrapDestination field).5. Type in the maximum access level of the SNMP traps that you want sent to the managementstation.6. Press ENTER.7. Use the arrow keys to highlight the Enable Traps field (on the same row as the TrapDestination and Trap Community Name you have just configured). The default setting for thisfield is NO.8. Press SPACE or BACKSPACE to set the field to YES.9. Use the arrow keys to highlight the SAVE command field.10. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.11. Repeat this procedure as necessary to set each Trap Destination.
