Chapter 7: General Configuration Using Local Management140HSIM-W6 User’s GuideBridge_PortX — Use this command field to select the HSIM-W6 bridge port you want toconfigure.Selecting a Spanning Tree ProtocolTo select the Spanning Tree protocol to be used by the HSIM-W6, perform the following steps:1. Use the arrow keys to highlight the SPANNING TREE PROTOCOL field.2. Press SPACE or BACKSPACE to select [IEEE 802.1], [DEC], or [NONE].3. Use the arrow keys to highlight the SAVE command field.4. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.Selecting the Bridge Port Administrative StatusTo select the bridge port administrative status, perform the following steps:1. Use the arrow keys to highlight the [BRIDGE_PORT XX] field at the bottom of the BridgeSetup screen.2. Press SPACE or BACKSPACE to select the bridge port you want to configure. The selectedbridge port displays in the Bridge Port Admin Status field.3. Use the arrow keys to highlight the BRIDGE PORT ADMIN STATUS: PORT X - - > ALLPORTS [ENABLED] field.4. Press SPACE or BACKSPACE to select ENABLE or DISABLE.For example, the following bridge setup indicates that bridge port 01 is configured to bridgetraffic to all ports:BRIDGE PORT ADMIN STATUS: PORT 01 - - > ALL PORTS [ENABLED]5. Use the arrow keys to highlight the SAVE command field.6. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
