3-1CHAPTER 3INSTALLATIONThis chapter outlines the procedure for installing your MRXI andconnecting it to a network. Ensure that your network meets theguidelines and requirements outlined in Chapter 2, InstallationRequirements/Specifications, before installing the MRXI.3.1 UNPACKING THE MRXIUnpack the MRXI as follows:• Remove the two plastic bags containing the accessories.• Remove the MRXI from the shipping box.• Slide the two foam end caps off the MRXI.• Remove the MRXI from the protective plastic bag and set it aside toprevent damage.Before you install the MRXI visually inspect the unit and check thecontents of the accessory package. Contact Cabletron Systems TechnicalSupport immediately if you find any discrepancies.3.2 ATTACHING THE STRAIN RELIEF BRACKETAttach the strain relief bracket to the front of the MRXI as follows:1. Locate the strain relief bracket and four 8-32 x 3/8” screws from theMRXI installation kit.Warning: Use of longer screws may cause damage to the unit orelectrical shock.2. Attach the strain relief bracket to the bottom of the MRXI as shown inFigure 3-1.
