LOCAL MANAGEMENT5-135. Enter the subnet mask into this field. The format for this entry isXXX.XXX.XXX.XXX with values for XXX being from 0 to 255.6. Press the Return key.7. Use the arrow keys to highlight the SAVE IP option and press theReturn key, (or press F6). The message “SAVED OK” appears andthe changes are saved to memory.Please note that the first time you try to exit the screen without savingyour changes, you will get a “NOT SAVED?” message. If youproceed to exit without saving, you will lose your edits.5.4.4 Setting the Default GatewayThe Default Gateway field allows you to describe the router throughwhich the MRXI will be forwarding IP packets.To set the Default Gateway:1. Use the arrow keys to highlight the Default Gateway field.2. Enter the gateway’s default mask in this field. The format for this entryis XXX.XXX.XXX.XXX with values for XXX being from 0 to 255.3. Press the Return key. If your entry is accepted as a valid defaultgateway, “OK” appears to the right of the field.5.4.5 Setting the UPS OptionTo connect to the Uninterruptible Power Supply (UPS) through the LocalManagement:1. Use the arrow keys to highlight the Serial Port 2 Application: field.2. Press the Return key so that “UPS” appears in the field. This fieldtoggles between “OFFLINE” and “UPS”.3. Use the arrow keys to highlight the Serial Port 2’s Baud Rate field andpress the Return key so that “2400 Connect?” appears in the field.4. Use the arrow keys to highlight Connect? and press the Return key.5. Enter Y if you want to connect a UPS, or N if you do not want a UPSconnection. If you pressed Y, you are connected to the UPS.