Using the Single CD PlayerInsert a CD partway into the slot, label side up. Theplayer will pull it in. If the ignition and the radio are on theCD will begin playing. A CD may be loaded with the radiooff but it will not start playing until the radio is on.If the ignition or radio is turned off with a CD in theplayer, it will stay in the player. When the ignitionor radio is turned on, the CD will start to play where itstopped, if it was the last selected audio source.When the CD is inserted, CD will appear on the display.As each new track starts to play, the track numberwill appear on the display.The CD player can play the smaller 3 inch (8 cm) singleCDs with an adapter ring. Full-size CDs and thesmaller CDs are loaded in the same manner.If playing a CD-R the sound quality may be reduceddue to CD-R quality, the method of recording, the qualityof the music that has been recorded, and the way theCD-R has been handled. There may be an increasein skipping, difficulty in finding tracks, and/or difficulty inloading and ejecting. If these problems occur try aknown good CD.Do not add paper labels to CDs, they could get caughtin the CD player.If an error appears on the display, see “CD Messages”later in this section.When a CD is inserted the CD functions will appear onthe display above the pushbuttons, in place of thepreset stations (if programmed).F1 PREV (Previous): Press this pushbutton to go tothe previous track. Press and hold this pushbuttonto reverse quickly within a track. Release the pushbuttonto play the passage. The elapsed time of the track willappear on the display.F2 NEXT: Press this pushbutton to go to the next track.Press and hold this pushbutton to advance quickly withina track. Release the pushbutton to play the passage.The elapsed time of the track will appear on the display.F3 RDM (Random): Press this pushbutton to listen tothe tracks in random, rather than sequential, order.RANDOM will appear on the display. Press RDM againto turn off random play. RANDOM will disappearfrom the display.3-93