Installing the Third Row SeatTo install the seat, do the following:1. Open the liftgate to access the rear of the vehicle.2. Slide the front outboard seat wheels into the track onthe floor and roll the seat forward. The front latchesshould lock into place. If the latches do not lock, trytilting the rear of the seat upward slightly.3. Lower the rear of the seat and push down on theseat to engage the rear floor latches.{CAUTION:A seat that is not locked into place properlycan move around in a collision or sudden stop.People in the vehicle could be injured. Be sureto lock the seat into place properly wheninstalling it.4. Push and pull on the seat to make sure it is lockedinto place. The seatback cannot be raised to theupright position unless the seat is secured tothe floor.5. Pull up on the seatback until it locks into the uprightposition.{CAUTION:If the seatback is not locked, it could moveforward in a sudden stop or crash. That couldcause injury to the person sitting there. Alwayspush and pull on the seatback to be sure it islocked.6. Push and pull on the seatback to make sure it islocked.{CAUTION:A safety belt that is improperly routed, notproperly attached, or twisted will not providethe protection needed in a crash. The personwearing the belt could be seriously injured.After raising the rear seatback, always checkto be sure that the safety belts are properlyrouted and attached, and are not twisted.7. Make sure the safety belts are returned to theoriginal position over the seatbacks.1-28
