The lever returns to its starting position when it isreleased.If after signaling a turn or lane change the arrow flashesrapidly or does not come on, a signal bulb may beburned out.Have the bulbs replaced. If the bulb is not burned out,check the fuse. See Fuses and Circuit Breakers onpage 6‑117.Turn Signal On ChimeIf the turn signal is left on for about 1 mile (1.6 km), awarning chime will sound and the TURN SIGNAL ONmessage will appear on the Driver Information Center(DIC) display. See “Turn Signal On” under DICWarnings and Messages on page 4‑76 for moreinformation.Headlamp High/Low-Beam ChangerPush forward on the turn signal/multifunction lever tochange the headlamps from low to high beam. Pull thelever back and then release it to change from high tolow beam.If you turn the vehicle off with the high beams on, thenext time you start your vehicle the low beams willbe on.To re-activate high beams, pull lever toward you andthen push it forward again.This light on theinstrument panel clusterwill be on, indicatinghigh-beam usage.4-5Ofrecido por www.electromanuales.com
