Reprogramming a Single HomeLink®ButtonTo program a device to HomeLink® using a HomeLink®button previously trained, follow these steps:1. Press and hold the desired HomeLink® button. Donot release the button.2. The indicator light will begin to flash after20 seconds. While still holding the HomeLink®button, proceed with Step 2 under “ProgrammingHomeLink® .”Resetting DefaultsTo reset HomeLink® to default settings do the following:1. Hold down the two outside buttons for about20 seconds until the indicator light begins to flash.2. Continue to hold both buttons until the HomeLink®indicator light turns off.3. Release both buttons.For questions or comments, contact HomeLink® at1-800-355-3515, or on the internet atwww.homelink.com.Storage AreasGlove BoxTo open your glove box, lift up the latch and pull thedoor open.Cupholder(s)Your vehicle is equipped with cupholders for the frontand rear passengers.The cupholders are located in the center console for thefront passengers and on the rear of the center consolefor the rear passengers.To use the front cupholders, press down on the accessdoor and release. The door will then open. Push thedoor back down to close it.To use the rear cupholders, pull down on the doorlocated on the back of the console.2-44
