Finding a StationBAND: Press this button to switch between AM, FM1,FM2, or XM1, XM2 (USA only, if equipped). Thedisplay will show your selection.TUNE: Turn this knob to choose radio stations.q SEEK r: Press the right or the left arrow to seekto the next or to the previous station and stay there.The radio will seek only to stations that are in theselected band and only to those with a strong signal.q SCAN r: Press and hold one of the arrows formore than two seconds. The radio will produce one beep.The radio will scan to a station, play for a few seconds,then go on to the next station. SCAN will be displayed.Press one of the arrows again to stop scanning.The radio will scan only to stations that are in the selectedband and only to those with a strong signal.To scan preset stations, press and hold one of the arrowsfor more than four seconds. The radio will produce twobeeps. The radio will scan to the first preset station, playfor a few seconds, then go on to the next preset station.PSCN will be displayed. Press one of the arrows again orone of the pushbuttons to stop scanning.The radio will scan only to preset stations that are in theselected band and only to those with a strong signal.Setting Preset StationsThe six numbered pushbuttons let you return to yourfavorite stations. You can set up to 30 stations (six AM,six FM1 and six FM2, or six XM1 and six XM2 (USAonly, if equipped), by performing the following steps:1. Turn the radio on.2. Press BAND to select AM, FM1, FM2, or XM1,or XM2.3. Tune in the desired station.4. Press AUTO EQ to select the equalization that bestsuits the type of station you are listening to.5. Press and hold one of the six numberedpushbuttons. The radio will produce one beep.Whenever you press that numbered pushbutton, thestation you set will return and the bass and trebleequalization that you selected will also beautomatically selected for that pushbutton.6. Repeat the steps for each pushbutton.3-73
