3. Check both sides of the dipstick, and read the lowerlevel. The fluid level must be in the COLD area,below the cross-hatched area, for a cold check or inthe HOT area or cross-hatched area for a hotcheck. Be sure to keep the dipstick pointed down toget an accurate reading.4. If the fluid level is in the acceptable range, push thedipstick back in all the way; then flip the handledown to lock the dipstick in place.How to Add FluidRefer to the Maintenance Schedule to determine whatkind of transmission fluid to use. SeePart D:Recommended Fluids and Lubricants on page 6-18.Add fluid only after checking the transmission fluid whileit is hot. (A cold check is used only as a reference.) Ifthe fluid level is low, add only enough of the proper fluidto bring the level up to the HOT area for a hot check.It doesn’t take much fluid, generally less than onepint (0.5 L).Don’t overfill.Notice: We recommend you use only fluid labeledDEXRON® -III, because fluid with that label ismade especially for your automatic transmission.Damage caused by fluid other than DEXRON ® -III isnot covered by your new vehicle warranty.• After adding fluid, recheck the fluid level asdescribed underHow to Check.• When the correct fluid level is obtained, push thedipstick back in all the way; then flip the handledown to lock the dipstick in place.5-23
