This device complies with RSS-210 of Industry Canada.Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) thisdevice must accept any interference, includinginterference that may cause undesired operation ofthe device.Changes and modifications to this system by other thanan authorized service facility could void authorizationto use this equipment.Programming the HomeLink ®TransmitterDo not use the HomeLink® Transmitter with any garagedoor opener that does not have the “stop and reverse”feature. This includes any garage door opener modelmanufactured before April 1, 1982. If you have a newergarage door opener with rolling codes, please besure to follow steps 6 through 8 to complete theprogramming of your HomeLink® Transmitter.Read the instructions completely before attempting toprogram the HomeLink® Transmitter. Because ofthe steps involved, it may be helpful to have anotherperson available to assist you in programming thetransmitter.Keep the original transmitter for use in other vehicles aswell as for future HomeLink® programming. It is alsorecommended that upon the sale of the vehicle, theprogrammed HomeLink ® buttons should be erased forsecurity purposes. Refer to “Erasing HomeLink® Buttons”or, for assistance, contact HomeLink® on the internet at:www.homelink.com or by calling 1-800-355-3515.Be sure that people and objects are clear of thegarage door or gate operator you are programming.When programming a garage door, it is advised to parkoutside of the garage.It is recommended that a new battery be installed inyour hand-held transmitter for quicker and moreaccurate transmission of the radio frequency.Your vehicle’s engine should be turned off whileprogramming the transmitter. Follow these steps toprogram up to three channels:1. Press and hold down the two outside buttons,releasing only when the indicator light begins toflash, after 20 seconds. Do not hold down thebuttons for longer than 30 seconds and do notrepeat this step to program a second and/or thirdtransmitter to the remaining two HomeLink® buttons.2. Position the end of your hand-held transmitter about1 to 3 inches (3 to 8 cm) away from the HomeLink ®buttons while keeping the indicator light in view.2-42