Black plate (2,1)Cadillac SRX Owner Manual (GMNA-Localizing-MidEast-8087806) - 2015 -CRC 1st Edition - 5/19/146-2 Lighting; (Parking Lamps): Turns on theparking lamps including all lamps,except the headlamps.3 (Headlamps): Turns on theheadlamps together with the parkinglamps and instrument panel lights.A warning chime sounds if the driverdoor is opened when the ignitionswitch is off and the headlampsare on.# (Front Fog Lamps): Press toturn the lamps on or off.See Front Fog Lamps on page 6-6.IntelliBeam ® SystemIf equipped, this system turns thevehicle's high-beam headlamps onand off according to surroundingtraffic conditions.The system turns the high-beamheadlamps on when it is darkenough and there is no other trafficpresent.This light comes on in theinstrument cluster when theIntelliBeam system is enabled.Turning On and EnablingIntelliBeamTo enable the IntelliBeam system,with the turn signal lever in theneutral position, turn the exteriorlamp control to AUTO. The bluehigh-beam on light appears on theinstrument cluster when the highbeams are on.Driving with IntelliBeamThe system only activates the highbeams when driving over 40 km/h(25 mph).There is a sensor near the topcenter of the windshield thatautomatically controls the system.Keep this area of the windshieldclear of debris to allow for bestsystem performance.The high-beam headlamps remainon, under the automatic control,until one of the following situationsoccurs:. The system detects anapproaching vehicle'sheadlamps.. The system detects a precedingvehicle's taillamps.. The outside light is brightenough that high-beamheadlamps are not required.. The vehicle's speed drops below20 km/h (12 mph).. The IntelliBeam system can bedisabled by the High/Low-BeamChanger or the Flash-to-Passfeature. If this happens, theHigh/Low-Beam Changer mustbe activated two times withinfive seconds to reactivate theIntelliBeam system. Theinstrument cluster light will come
