Black plate (3,1)Cadillac SRX Owner Manual (GMNA-Localizing-MidEast-8087806) - 2015 -CRC 1st Edition - 5/19/14Lighting 6-3on to indicate the IntelliBeam isreactivated. See HeadlampHigh/Low-Beam Changer onpage 6-3 or Flash-to-Pass onpage 6-3.The high beams may not turn offautomatically if the system cannotdetect another vehicle's lampsbecause of any of the following:. The other vehicle's lamps aremissing, damaged, obstructedfrom view, or otherwiseundetected.. The other vehicle's lamps arecovered with dirt, snow, and/orroad spray.. The other vehicle's lamps cannotbe detected due to denseexhaust, smoke, fog, snow, roadspray, mist, or other airborneobstructions.. The vehicle's windshield is dirty,cracked, or obstructed bysomething that blocks the viewof the light sensor.. The vehicle is loaded such thatthe front end points upward,causing the light sensor to aimhigh and not detect headlampsand taillamps.. Driving on winding or hilly roads.The high-beam headlamps mayneed to be disabled if any of theabove conditions exist.Headlamp High/Low-Beam ChangerPush the turn signal lever awayfrom you and release to turn thehigh beams on. To return to lowbeams, push the lever again or pullit toward you and release.This indicator light turns on in theinstrument cluster when thehigh-beam headlamps are on.Flash-to-PassThe flash-to-pass feature works withthe low beams on or off.To flash the high beams, pull theturn signal lever all the way towardyou, then release it.Daytime RunningLamps (DRL)If equipped, DRL can make it easierfor others to see the front of yourvehicle during the day.A light sensor on top of theinstrument panel makes the DRLwork, so be sure it is not covered.The DRL system makes thelow-beam headlamps come on at areduced brightness or for vehicleswith High Intensity Discharge (HID)headlamps, the DRL lights will comeon when the following conditionsare met:. The ignition is in the ON/RUN mode.