117Using a Memory CardUsing an Optional FlashYou can use E-TTL II-compatible Canon Speedlite flashes designed for use with Canon SLR cameras,including the 420EX/430EX/430EX II/550EX/580EX/580EX II models, to record natural still images underlow light conditions. Refer also to the instruction manual of the Speedlite flash.The following procedures are explained using a Canon 580EX II Speedlite Flash.Connecting a Speedlite FlashWhen connecting a Canon Speedlite flash you cannot use the Off-Camera Shoe Cord designed for CanonEOS SLR cameras.Always turn off the camcorder when connecting or removing the flash.1. Slip the flash’s mounting foot all the way into the camcorder’s hot shoe.2. Slide the lock lever on the mounting foot to the right until it clicks in place.To remove the flash:Press and hold the lock-release button and slide the lock lever to the left and then remove the flash form thehot shoe.Using the Flash1. Set the dial to a recording mode other than M and turn on the flash.• While the Speedlite flash is charging, the indicator will flash in white. Once charged, the indicatorwill stay on in green.• If the indicator keeps flashing in white for a long time, replace the flash’s batteries.2. Press the PHOTO button to record a still image. Wait until the flash is charged before recording the still image. You can record a still image whilethe flash is charging, but the flash will not go off. Turn off the Speedlite flash when you are not using it. The flash will not go off during exposure lock and in the M Manual mode. While using the flash, the shutter speeds that can be set in Tv mode are 1/4 – 1/500. The camcorder does not support the Bounce Flash function or the Wireless Multiple Flash Systemfunction of the Speedlite 420EX/430EX/430EX II/550EX/580EX/580EX II flashes. The camcorder does not support the ST-E2 Wireless Speedlite Flash Transmitter or the WirelessMaster/Slave Control function of the Speedlite 420EX/430EX/430EX II/550EX/580EX/580EX IIflashes. When recording under very dark conditions, as you keep the PHOTO button pressed halfway, theAF assist lamp of the Speedlite flash may light up (only when recording using autofocus and with[CAMERA SETUP] [FOCUS PRI.] set to [ON]). The Speedlite flash will not go off when the drive mode is set to Auto Exposure Bracketing.