144RecordingPlaybackMemory Card OperationsAbout the LCD screenThe LCD screen is produced with extremely high-precision manufacturing techniques, with more than99.99% of the pixels operating to specification. Less than 0.01% of the pixels may occasionally misfire orappear as black, red, green or blue dots. This has no effect on the recorded image and does not constitute amalfunction.Problem Cause SolutionA vertical light bar appears on the screen. Bright light in a dark scene may cause avertical light bar (smear) to appear. This isnot a malfunction.Record in Av mode with an aperture valuein the range F5.6–F8.0.59Viewfinder picture is blurred. Viewfinder is not adjusted. Adjust the viewfinder with the dioptricadjustment lever.17Audio is not recorded. The input channel is not set correctly. Set the appropriate input channel. 49Microphone connected to the XLR terminalneeds to be powered by the phantom power.Set the switch to ON. 49Audio is recorded in a very low level. The switch is set to M, andrecording level is set too low.Adjust the audio level correctly. 49Microphone attenuator is turned on. Set the FRONT MIC ATT. switch or theswitch to OFF.49Problem Cause SolutionPressing the playback button does notstart playback.Camcorder is turned off, or is not set tomode.Set the camcorder to mode. 105Cassette is not loaded. Load a cassette. 23Tape is running, but image will not appearon the TV screen.Video heads are dirty. Clean the video heads. 141You attempted to play back or dub acopyright protected tape.Stop playback/dubbing. –The video output cable is not connectedcorrectly.Verify that the video cable is connectedproperly.–While playing back a tape recorded in HDVstandard there are brief stops in theplayback picture.Video heads are dirty. Clean the video heads with a dry cleaningcassette.141Problem Cause SolutionMemory card cannot be inserted. Memory card was not facing the correctdirection.Turn the memory card over and tryinserting it again. 24Memory card cannot be recorded. No memory card. Insert a memory card. 24Memory card is full. Replace the memory card or erase images. 120Memory card is not initialized. Initialize the memory card. 122The folder and file numbers have reachedtheir maximum value.Set [FILE NOS.] to [RESET] and insert a newmemory card. 111Memory card cannot be played back. The dial or / (card/tape)switch are not set to the correct position.Set the dial to VCR/PLAY and the/ (card/tape) switch to . 118Image cannot be erased. Image is protected. Cancel the protection. 121On an SDHC or SD memory card, the write-protect switch is set to the locked position.Change the position of the write-protectswitch on the memory card to unlock it. 141flashes red. Card error occurred. Turn off the camcorder. Remove andreinsert the memory card. Initialize thememory card if flashing persists.122