78Activate the HD/SD SDI output and select the appropriate video output option (HD or SD).1. Set the dial to .2. Open the menu and select [SIGNAL SETUP]. Select [SDI OUTPUT] and set it to [ON] or[ON(OSD)].3. From the same [SIGNAL SETUP] submenu select [SDI SPEC.]. Select [AUTO] or[SD LOCKED] to match the video output you wish to use.4. Close the menu.When [SDI OUTPUT] is set to [ON(OSD)], will appear on the screen and on-screen displays willbe included in the video signal output from the SDI terminal.When [SDI OUTPUT] is set to [ON(OSD)]: The on-screen displays included in the video output signal are determined by the display levelselected with the DISP. button ( 31). Markers (safety zone guide, level/grid markers, etc.) arenever included in the video signal output. The [SIGNAL SETUP] [COMP.OUT] setting is not available.Using the HD/SD COMPONENT OUT or VIEWFINDER COMPONENT OUT TerminalUse the HD/SD COMPONENT OUT terminal to monitor the video that the camcorder is recording and usethe VIEWFINDER COMPONENT OUT terminal to monitor the picture on the viewfinder screen.When using the HD/SD COMPONENT OUT terminal, select the appropriate component video signaldepending on the TV or monitor you connect.Open the menu and select [SIGNAL SETUP]. Select [COMP.OUT], select a setting optionand close the menu.2SDHD/SDHD/SDHD/SDAUDIOVIDEOINPUTPbPrYRLSTV-290N StereoVideo Cable* (supplied)Signal flowDTC-1000 Component Video Cable (supplied)Open the terminal coverRedBlueGreenYellowWhiteRed* The audio signal is separate from the component video signalSignal flow
