have to turn on your device or select Play mode manuallyafter connecting the device to the machine. Performnecessary operations before connecting your devicereferring to its instruction manual.If the error is still not resolved, check if you can print anotherphotograph.Failed to scan.Check orientation/position and checkthat platen/sheet is clean.Scanning the print head alignment sheet has failed.Press the OK button to dismiss the error, then take theactions described below.Make sure that the print head alignment sheet is set inthe correct position and orientation on the Platen Glass.Make sure the Platen Glass and the print head alignmentsheet are not dirty.Make sure the type and size of loaded paper is suitablefor Automatic Print Head Alignment.For Automatic Print Head Alignment, always load onesheet of A4 or letter-sized plain paper.Make sure if Print Head nozzles are clogged.Print the nozzle check pattern to check the status of thePrint Head.Routine MaintenanceIf the error is not resolved, connect the machine to thecomputer and align the Print Head on the printer driver.Aligning the Print Head PositionAn unsupported USB hub is connected.Remove the hub.If a PictBridge compliant device is connected via a USB hub,remove the hub and connect it directly to the machine.B200Printer error has occurred.Unplug the power cord and contact theservice center.Turn off the machine, and unplug the power cord of themachine from the power supply.Contact the service center.****Printer error has occurred.Turn off power then back on again.If problem persists, see the manual."****" is displayed in the alphanumeric character anddepends on the error occurred.5100/5110 is displayed:Cancel printing, and turn off the machine. Then clear thejammed paper or protective material that is preventingthe Print Head Holder from moving, and turn on themachine again.ImportantBe careful not to touch the components inside themachine. The machine may not print out properly ifyou touch it.If the problem is not resolved, contact the servicecenter.6000 is displayed:If any object is placed in front of the machine, remove it.Open the Paper Output Tray gently, then turn the poweroff and back on.In other cases:Turn off the machine, and unplug the power cord of themachine from the power supply.Plug the machine back in and turn the machine back on.If the problem is not resolved, contact the service center.Scanner is not operating correctly. Turn off the machine, and unplug the power cord of themachine from the power supply.After a while, plug the power cord of the machine back in,and then turn on the machine. If the same error occurs,contact the service center.The card is currently writable from PC. The Card Slot is set to Writable from USB PC or WritablePage 784 of 949 pagesAn Error Message Is Displayed on the LCD
