viii PrefaceUSERS IN CANADAPRE-INSTALLATION REQUIREMENTS FOR CANONFACSIMILE EQUIPMENTA. LocationSupply a suitable table, cabinet, or desk. See Appendix for the unit’sdimensions and weight.B. Order Information1. Provide only a single-line to touch-tone or rotary telephone setterminated with a standard 4-pin modular phone plug.(Touch-tone is recommended if available in your area.)2. Order an CA11A modular jack (USOC code), which should beinstalled by the phone company. If the CA11A jack is not present,installation cannot occur.3. Order a normal business line from your telephone company’sbusiness representative. The line should be a regular voice gradeline or equivalent. Use one line per unit.DDD (DIRECT DISTANCE DIAL) LINEorIDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IFYOU COMMUNICATE OVERSEASCanon recommends an individual line following industry standards[e.g., the 2500 (Touch Tone) or 500 (Rotary/Pulse Dial) telephones]. Adedicated extension of a PBX unit without “Camp On” signals is alsopermissible with a fax unit. Key telephone systems are not recommendedbecause they send non-standard signals to individual telephones forringing and special codes, which may cause a fax error.C. Power RequirementsThe power outlet should be a three-prong grounded receptacle(Single or Duplex). It should be independent from copiers, heaters,air conditioners, or any electric equipment that is thermostaticallycontrolled. The rated value is 120 volts and 15 amperes. The CA11Amodular jack should be relatively close to the power outlet tofacilitate installation.n
