95EEditingSetting the Audio MixAUDIOMONITORMIXBALANCEST-1 ST-2OFFPOWERP.SCANMOVIEPLAYWhen you play back a tape that was recorded in 12 bit mode, you can set theaudio output to play: stereo 1 (the original sound), stereo 2 (any new sound,dubbed to the tape after recording), or mix the balance between the two.• Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/donot need to select the audio mix. The same is true for the 12 bit stereo 1 mode,unless new sound has been added post-recording.1. Choose the output.• Press AUDIO MONITOR on the wireless controller.• Starting with the last selected setting, 4 settings appear as you push thebutton:– STEREO1 for just stereo 1.– STEREO2 for just stereo 2.– MIX/FIXED for an equal mix of stereo 1 and 2.– MIX/VARI. (mix variable) for when you want to mix the balance betweenstereo 1 and 2.• To simply choose STEREO1, STEREO2 or MIX/FIXED, make sure yourchoice appears on the display.• If you choose MIX/VARI., you can go on to mix the balance.• Use the ST-1/ST-2 keys to mix the balance. A bar showing the mix appearson the screen for 4 seconds.• When you have chosen the output, STEREO1, STEREO2, MIX/FIXED orMIX/VARI. is shown in the top left of the display for a few seconds. If you turnthe power off the output is set to STEREO1.PLAY VCR( )
