107Setting Various FunctionSetting Up Functions from MenusSetting for Slideshow (SX80 II)[Slideshow interval]You can project the images stored in aPictBridge-compatible device (P114) or aUSB flash memory (P118) in the slide-show.Use [<] / [>] to set the interval (minutes:seconds) of projection (60 minutes = max-imum).Set [-- : --] if no slideshow is performed.When the setting is completed, press theMENU button.• [-- : --] is the factory default.• The maximum length of slideshow timeis 60 minutes (60:00).• Use the USB file browser for the projec-tion from the USB flash memory. Formore details, refer to the page 120.Setting up the Remote Control Channel[Other settings] - [Remote control]You can set different channels to differentremote controls, if you use two projectorsat the same time.Press the OK button to accept your settingand then press the MENU button.• The factory defaults is [Ch1] for bothprojector and remote control.• After changing the channel on themenu, be sure to change the channel ofthe remote control, too.Selecting a Channel on the Remote Con-trolYou can change the channel on theremote control as follows:HDMI COMPONENTDIGITAL PC VIDEO/S-VIDEOANALOG PC USBSlideshow intervalSystem settingsHDMI COMPONENTDIGITAL PC VIDEO/S-VIDEOANALOG PC USBCh1 Select the channel of the remote controlused for this projector, and press the OKbutton.Ch2Ch1 Press the OK button and [ ] for 3 sec-onds at the same time.Ch2 Press the OK button and [>] for 3 sec-onds at the same time.Other settingsSystem settingsRemote control<
