Starting Projection505 Press the AUTO SET button.The auto setup function performs the following operations automatically:SX80 MarkII: focusing and keystone distortion adjustment, input signal setting, andscreen color correctionSX800: keystone distortion adjustment and input signal settingFor more details, refer to the page 52.If the projector is projecting an image properly with [AUTO SETUP], the projection iscomplete.In SX800, adjust the focus and correct the screen color manually.For how to turn off the projector, refer to the page 68. Perform the appropriate opera-tion depending on the following situations.■When the Language Selection Screen AppearsA window appears when the projector is turned on for the first time. You can select a lan-guage to be used by the projector for displaying menus and messages in the window.Select the desired language with the pointer buttons and press the OK button.You can change the language from the menu at a later time. (P105)If you cannot check the language selection screen due to the out of focus, press theFOCUS button to adjust the focus. (P59)Changing Operations When Projector is Turned OnYou can change operations when the projector is turned on as follows:• You can turn on the projector by connecting the power cord without pressing thePOWER button. (P104)• You can specify whether to enable or disable the LED illumination lamp. (P106)• You can change the countdown window. (P90)• You can skip the countdown window. (P49)Using the Power Saving Mode (power management)When you enable the power management mode, the lamp is automatically turnedoff if the projector receives no signal input for a certain period of time. (P103)An item highlighted in orange will be selected.Remote control Top control
