55Selecting an Input Signal (INPUT)Projecting an Image■Selecting an Input Signal1 Press the INPUT button to pop up a window shown at the lower right.The currently active input signal is marked with a circle and highlighted in orange.An input signal that is ready for projection is displayed in white. When no signal isreceived, it is displayed in gray.In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed ingray even if they are ready for projection.2 The selection is toggled through available input signal types by pressing the INPUTbutton.• You can select the target input signal with [ ] / [ ].• Only the input signals displayed in white can be selected.3 Press the OK button to determine the input signal type.If no button is pressed in 4 seconds, the selected input signal type is chosen.When you select [USB] with no PictBridge enabled equip-ment or an USB flash memory connected and pressing theOK button, a window waiting for you to connect a Pict-Bridge enabled equipment or an USB flash memoryappears. For more details, refer to "Projecting an Imagefrom a Digital Camera (SX80 II)" (P114 – P117) or "Project-ing Data on USB Flash Memory (SX80 II)" (P118 – P124).Remote control Top control SX80 MarkII SX800<<
