1676 AppendixIf you have forgotten the settings and want to set the camera from the beginning, restore the factory default settings first.It is recommended that you create a backup file using [Back Up Settings] in the Camera Management Tool before restoringthe factory default settings.Note• For details on using Camera Management Tool, please refer to “Camera Management Tool User Manual”.• For factory default settings, please refer to p. 169.Restoring the Initial Setting from theMaintenance Page in the Web BrowserTo display the settings menu, you need to enter the IPaddress of the camera, user name and administratorpassword (p. 31).The maintenance page appears.A confirmation message appears, asking if you wantto restore the default settings. To restore the defaultsettings, click [OK].Except for the following items, all user-definedsettings will be discarded and restored to factorydefault settings after the camera is rebooted.– Administrator password– Network LAN, IPv4, IPv6– Date and time– Host access restrictions for access control– SSL/TLS– 802.1XRestoring Factory Default Settings withthe Reset Switch on the CameraIf you have forgotten or do not know the IP address of thecamera or your Administrator password, you cannotoperate the camera via the network. In this case, pressthe reset switch at the back of the camera.For top cover removal, see the “Installation Guide”included with the camera.Restore Default Settings1 Launch the web browser and display the settingsmenu.2 On the Setting Menu page, click [Maintenance].3 Click [Exec] under [Restore Default Settings].Caution• You must not turn off the camera while it isperforming the [Restore Default Settings]operation. Turning off the camera at this stagemay result in disabling its ability to boot correctly.• Once [OK] is clicked, you can no longer stop theprocess of restoring the default settings.1 For VB-S30D/VB-S31D/VB-S800D/VB-S805D,remove the top cover.
