Connecting to an External Monitor98NOTES• The HDMI OUT terminal on the camcorder is for output only. Do not connect it to an HDMI outputterminal on an external device, as this may damage the camcorder.• Correct operation cannot be guaranteed when connecting the camcorder to DVI monitors.• Video may not be output correctly depending on the monitor.• If the connected monitor is not compatible with the signal output from the camcorder, then HDMIoutput will stop.• The time code signal will not be output from the HDMI OUT terminal in the following cases.- In mode.- When slow & fast motion recording is activated.- When the output is 720x480 / 59.94P.• The frames value in the time code will run from 0 to 29 instead of 0 to 23 in the following cases.- > [£ Display Setup] > [SDI/HDMI Scan Mode] (s only) or [HDMI Scan Mode](t only) is [ PsF (Forced 1080i)] and the frame rate is 23.98P.- When the output is 1280x720.• You can set both > [3 Recording Setup] > [Rec Command] and [HDMI Time Code] to[i On] to use the camcorder’s START/STOP button to control also the recording operation of anexternal recorder connected to the HDMI OUT terminal. The camcorder’s time code signal will beoutput as well.
