Chapter 66-26T-6-25T-6-26T-6-2782 +3.3V OUT Power supply (+3.3V)83 +3.3V OUT Power supply (+3.3V)84 +3.3V OUT Power supply (+3.3V)85 GND - GND86 GND - GND87 GND - GND88 GND - GNDJ1201 (Network)Pin Number Signal name IN/OUT Function1 TX+ OUT Ethernet data TX line (+)2 TX- OUT Ethernet data TX line (-)3 RX+ IN Ethernet data RX line (+)4 - - Not used5 - - Not used6 RX- IN Ethernet data RX line (-)7 - - Not used8 - - Not used9 GREEN_LED_C OUT Link LED (green:100Mb/s) cathode terminal10 GREEN_LED_A OUT Link LED (green:100Mb/s) anode terminal11 YELLOW_LED_C OUT Link LED (yellow:10Mb/s) cathode terminal12 YELLOW_LED_A OUT Link LED (yellow:10Mb/s) anode terminalJ1801 (Connect to Power supply)Pin Number Signal name IN/OUT Function1 HD1_VHFBH OUT VH feedback voltage +2 HD1_VHFBG OUT VH feedback voltage -3 VH IN Power supply (+21.5V)4 GND - GND5 VH IN Power supply (+21.5V)6 GND - GND7 RGV20(VCC) IN Power supply (+21.5V)8 GND - GND9 VM IN Power supply (+26V)10 GND - GND11 VM IN Power supply (+26V)12 GND - GND13 VH_ENB OUT VH power supply ON/OFF signal14 PW_CONT OUT Normal/power saving switch signalJ2511 (Spur motor, Spur cam sensor, Mist fan, Cutter motor, Cutter right detection sensor)Pin Number Signal name IN/OUT Function1 SNS_3V_1 OUT Power supply (+3.3V)2 GND - GND3 CUTTER_R_SNS_R IN Cutter right detection sensor signal4 CUTTER_OUTA OUT Cutter motor driver signal A5 CUTTER_OUTB OUT Cutter motor driver signal B6 SNS_3V_1 OUT Power supply (+3.3V)7 GND - GND8 HAKUSHA_CAM_SNS_R IN Spur cam sensor output signal9 HAKUSHA_MOTOR_AM OUT Spur motor drive signal AM10 HAKUSHA_MOTOR_AP OUT Spur motor drive signal AP11 FAN_VM OUT Power supply (+26V)12 MIST_FAN_LOCK IN Mist fan lock signal13 MIST_FAN_PWM OUT Mist fan duty control signal14 GND - GNDJ1101 (Connect to HDD expansion PCB)Pin Number Signal name IN/OUT Function
