Canon iR1018 Series Portable Manual

Also see for iR1018: Driver guide Service manual Brochure & specs Advanced operation guide Quick start guide

Contents

Chapter 37Chapter 3 Error Code3.1 Error Code Details3.1.1 Error Code Details 0013-1429/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /T-3-1DisplayCodeDetail Code Main Cause/Symptom CountermeasureE000 0000 Startup errorThe temperature detected by the main or sub thermistor doesnot rise to the specified value during startup control.- Check the fixing film connector.- Replace the fixing film unit.- Replace the DC controller PCB.E001 0000 Abnormally high temperature (detected by main thermistor)The main thermistor detected an abnormally high temperature(235 deg C) during temperature control.- Check the connector of the fixing film unit.- Replace the fixing film unit.- Replace the DC controller PCB.0001 Abnormally high temperature (detected by sub thermistor)The sub thermistor detected an abnormally high temperature(300 deg C) during temperature control.- Check the connector of the fixing film unit.- Replace the fixing film unit.- Replace the DC controller PCB.E002 0000 Low temperature during temperature control.The target temperature is not reached during temperaturecontrol.- Check the connector of the fixing film unit.- Replace the fixing film unit.- Replace the DC controller PCB.E003 0000 Abnormally low temperature (detected by main thermistor)After the temperature detected by the main thermistor hasreached the specified value, it does not reach the specifiedvalue during initial rotation.- Check the connector of the fixing film unit.- Replace the fixing film unit.- Replace the DC controller PCB.0001 Abnormally low temperature (detected by sub thermistor)After the temperature detected by the sub thermistor hasreached the specified value, it does not reach the specifiedvalue during initial rotation.- Check the connector of the fixing film unit.- Replace the fixing film unit.- Replace the DC controller PCB.E010 0000 Main motor failureThe main motor is faulty. - Check the connector of the main motor.- Replace the main motor.- Replace the DC controller PCB.E019 0000 Waste toner full detectionThe waste toner full state was detected. Replace the drum unit0001 Waster toner full detection sensor is faulty.The waste toner full state was detected continuously for five ormore seconds while the main motor was turning.- Check the connector of the waster toner full sensor.- Replace the waste toner full sensor.- Replace the DC controller PCB.E100 0000 BD detection PCB failureThe BD detection PCB is faulty. - Check the connector of the BD detection PCB.- Replace the laser scanner unit.- Replace the DC controller PCB.E196 0001 Flash ROM write/read error - Replace the image processor PCB.The write/read of Flash ROM in the image processor PCB isfaulty.0002 PCL ROM write/read error - Replace the PCL PCB.- Replace the image processor PCB.The write/read of PCL ROM in the image processor PCB isfaulty.E197 0000 Printer engine communication errorErroneous communication between the DC controller PCB andimage processor PCB was detected.- Check the connectors of the DC controller PCB and imageprocessor PCB.- Replace the DC controller PCB for normal connection.- Replace the image processor PCB.E716 0000 Erroneous communication with optional cassetteDisconnection of the optional cassette was detected afterpower-on, detection of normal connection to the optionalcassette, and start of communication.- Check the connectors of the optional cassette PCB and DCcontroller PCB.- Replace the optional cassette PCB for normal connection.- Replace the DC controller PCB.