Canon iR1018 Series Portable Manual

Also see for iR1018: Driver guide Service manual Brochure & specs Advanced operation guide Quick start guide

Contents

Chapter 519Chapter 5 Service Mode5.1 Fax System Service Mode5.1.1 Service Soft Switch Settings (SSSW)5.1.1.1 Outline5.1.1.1.1 Bit Switch Composition0013-1304/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /The items registered and set by each of these switches comprise 8-bit switches. The figure below shows which numbers are assigned to which bits. Each bit has avalue of either 0 or 1.F-5-1Do not change service data identified as "not used"; they are set as initial settings.5.1.1.2 SSSW-SW015.1.1.2.1 List of Functions0013-1305/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /T-5-15.1.1.2.2 Detailed Discussions of Bit 00013-1306/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /Selects whether or not service error codes are output.When output is selected, service error codes is report.5.1.1.3 SSSW-SW035.1.1.3.1 List of Functions0013-1307/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /T-5-25.1.1.3.2 Detailed Discussions of Bit 70013-1308/ / / / iR1018 / iR1018J / / iR1022A / iR1022F / iR1022i / iR1022iF /Use it to enable/disable transmission of a 1080-Hz tonal signal before transmission of the CED signal.Select 'transmit' if errors occur frequently because of an echo when reception is from overseas.Bit Function 1 00 service error code output not output1 not used - -2 not used - -3 not used - -4 not used - -5 not used - -6 not used - -7 not used - -Bit Function 1 00 not used - -1 not used - -2 not used - -3 not used - -4 not used - -5 not used - -6 not used - -7 tonal signal before CED signal transmission transmit do not transmit001#SSSW0 0 0 0 0 0 0 0Bit 7Bit 6Bit 5Bit 4Bit 3Bit 2Bit 1Bit 0