Note• Automatic and Eject are valid only when you have selected Auto Cut > Yes in the printer driver.• With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut.• Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the presetcutting mode.• If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount before cuttingto prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some cases.Cut rolls manually in the following cases:Eject (when the paper surface is being scratched / to wait for ink to dry)Important• When cutting wide printed documents after ejection, have two people support the documents. If the paper drops, printeddocuments may be damaged.• Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing quality orcause rough cut edges.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-lect the Paper tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2 Press the OK button. The Paper Menu is displayed.3 Press ▲ or ▼ to select Paper Details, and then press the OK button.4 Press ▲ or ▼ to select the type of paper, and then press the OK button.5 Press ▲ or ▼ to select Cutting Mode, and then press the OK button.6 Press ▲ or ▼ to select Eject, and then press the OK button.iPF8400 Specifying the Cutting Method for RollsUser's GuideHandling and Use of Paper Handling rolls553
