Menu SettingsMenu SettingsMenu items are as follows.The printer menu is classified into regular menu items available when no print job is in progress and menu during print-ing items only available while printing is in progress. see "Printer Menu Operations." →P.663Regular menu Menu during printingPaper Menu Not displayedInk Menu The same Ink Menu as normal is displayed.Job Menu The same Job Menu as normal is displayed.Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed.• Adj. Fine Feed(*1)• Printer Info*1: Only displayed in the menu during printing. Not displayed in the regular menu.For instructions on selecting menu items, see "Menu Operations." →P.664For details on the displayed menu hierarchy, see "Menu Structure." →P.667Paper MenuThe Paper Menu is not displayed during printing.Setting Item Description, InstructionsLoad Paper Select either sheets or rolls and load the paper.Eject Paper Choose this item before removing loaded paper.Chg. Paper Type (*1) Change the type of paper loaded. (See "Changing the Type of Paper.")→ P.543Chg. Paper Size Change the size of paper loaded. (See "Specifying the Paper Length.")→ P.545 (See "Paper Sizes.") → P.528ManageRemainRoll Choose On to print a barcode at the end of a roll before you remove it.The printed barcode can be used in managing the amount of roll paperleft. Choose Off if you prefer not to print the barcode.(See "Keeping Track of the Amount of Roll Paper Left.") → P.550Paper Details (The type of paperis displayed here.)(*1)Head Height Adjust the Printhead height. (See "Troubleshooting Paper Abrasion andBlurry Images.") → P.809Skew Check Lv. If you print on Japanese paper (washi) or other handmade paper thathas an irregular width, choose Loose for a higher skew detectionthreshold, or choose Off to disable skew detection. However, if paper isloaded askew when detection is Off, note that paper jams or Platensoiling may occur.Cutting Mode Specify whether or not to cut with the standard round-bladed cutter.If you choose Automatic, the roll will be cut automatically using theCutter Unit, depending on the printer driver settings.Select Eject to prevent printed documents from falling immediately afterprinting such as when you wait for the ink to dry, etc. Manual printslines at the cut position instead of cutting after printing. If you selectManual, the setting screen for detection of the paper leading edge isdisplayed.(See "Specifying the Cutting Method for Rolls.") → P.552Cut Speed Choose the cutting speed. The preset selection represents the optimalcutting speed for the type of paper. We recommend keeping the presetcutting speed.If you use adhesive paper, choosing Slow helps prevent adhesive fromsticking to the cutter and keeps the cutter sharp.iPF8400 Menu SettingsUser's GuideControl Panel Printer Menu673