Cause Corrective ActionThe loaded paper is too small.(When you have attempted to print a test print sheetor other printer status information.)(See "Loading and Printing on Sheets.") → P.27The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button."Replace roll with 10 in. wide or larger roll."Cause Corrective ActionThe loaded paper is too small.(When you have attempted to print a test print sheet or other print-er status information.)Replace the roll with a roll 10 inches in width or larger as follows.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") → P.545(See "Removing the Roll Holder from Rolls.") → P.5482. Replace the roll with a roll 10 inches wide or larger.(See "Attaching the Roll Holder to Rolls.") → P.536(See "Loading Rolls in the Printer.") → P.539The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button.PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menu is set toPause or Hold Job, the width of the loaded roll does notmatch the width specified in Fit Roll Paper Width in the print-er driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the printerdriver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") → P.545(See "Removing the Roll Holder from Rolls.") → P.5482. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") → P.536(See "Loading Rolls in the Printer.") → P.539The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loadedin the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Lift up the Release Lever and reload the paper.(See "Loading Rolls in the Printer.") → P.539(See "Loading Sheets in the Printer.") → P.561If "Not finished printing. Finish printing re-maining jobs?" is displayed on the DisplayScreen, press the OK button.Printing will resume, starting from the page onwhich the error occurred.PaprWidth Mismatch iPF8400User's GuideError Message Messages regarding paper994
