Adjustments6H4866-02 133[5] Insert the Tray Gauge into the tray entrance and position the Go slot around the loader pin. The gauge shouldpass smoothly over the loader pin. This determines that the pin is not too high.Checking Pin Height (Go)[6] Insert the Tray Gauge into the tray entrance and position the No Go slot next to loader pin. The gauge shouldnot pass over the loader pin. This determines that the pin is not too low.Checking Pin Height (No Go)[7] If the pin height is incorrect, remove the bottom access cover, loosen the motor frame retaining screws andadjust the frame position as necessary. (see “Replacing the Stepper Motor” on Page 65)[8] Check Steps 5 and 6 again.
