Carrier 50TCQA04 Installation Instructions Manual

Also see for WeatherMaker 50TCQA07: Installation instructions Installation instructions Service and maintenance instructions

13C06108Fig. 9 -- Horizontal Conversion PanelsStep 8 — Install Outside Air HoodEconomizer and Two--Position Damper HoodPackage Removal and Setup -- Factory Option1. The hood is shipped in knock--down form and must befield assembled. The indoor coil access panel is used asthe hood top while the hood sides, divider and filter arepackaged together, attached to a metal support tray us-ing plastic stretch wrap, and shipped in the return aircompartment behind the indoor coil access panel. Thehood assembly’s metal tray is attached to the basepanand also attached to the damper using two plastic tie--wraps.2. To gain access to the hood, remove the filter accesspanel. (See Fig. 10.)FILTER ACCESS PANELOUTDOOR-AIR OPENING ANDINDOOR COIL ACCESS PANELCOMPRESSORACCESS PANELC06023Fig. 10 -- Typical Access Panel Locations3. Locate the (2) screws holding the metal tray to thebasepan and remove. Locate and cut the (2) plastictie--wraps securing the assembly to the damper. (SeeFig. 11) Be careful to not damage any wiring or cuttie--wraps securing any wiring.Hood PartsPlastic Tie WrapQty (2)Screws for Metal TrayQty (2)C08639Fig. 11 -- Economizer and Two--Position DamperHood Parts Location4. Carefully lift the hood assembly (with metal tray)through the filter access opening and assemble per thesteps outlined in Economizer Hood and Two–PositionHood.Economizer Hood and Two--Position Hood —NOTE: If the power exhaust accessory is to be installedon the unit, the hood shipped with the unit will not beused and must be discarded. Save the aluminum filter foruse in the power exhaust hood assembly.1. The indoor coil access panel will be used as the top ofthe hood. Remove the screws along the sides and bot-tom of the indoor coil access panel. See Fig. 12.TOPPANELINDOORCOILACCESSPANELINDOORCOILACCESSPANELCAULKHERETOPPANELC06025Fig. 12 -- Indoor Coil Access Panel Relocation2. Swing out indoor coil access panel and insert the hoodsides under the panel (hood top). Use the screwsprovided to attach the hood sides to the hood top. Usescrews provided to attach the hood sides to the unit. SeeFig. 13.