5 - HOW TO USE TOUCH PILOT CONTROL5.1 - User interfaceTouch Pilot is a 7” colour touch screen with quick display of alarms,current unit operating status, etc. It allows for web connectivityand custom language support (control parameters displayed inthe language selected by the user).This picture is for information only. It may differ from the actual look.If the touch screen is not used for a long period of time,the Welcome screen is displayed, and then it goes blank.The control is always active and the operating mode remainsunchanged. Press anywhere on the screen and the Welcomescreen will be displayed.5.2 - ConnectionsConnections are located on the bottom side of the controller.The controller comes with two RS485 ports, where the first port isused to connect to Modbus and the second RS485 port is usedfor internal communication. The Ethernet port allows for TCP/IPcommunication or BMS (Building Management System) connectionthanks to BACnet/IP communication.Legend1. USB connector2. Ethernet connector3. Internal bus (RS485)4. Internal bus (RS485)5. Power supply connector (24 VAC)(1) (2) (3) (4) (5)5.3 - Touch Pilot buttonsHome button Main Menu button Back buttonHome screen displayed Main Menu displayed Go back to the previous screenLogin button Start/Stop button Alarm buttonBasic access Unit is stopped (grey icon) No alarm active on the unitUser access Unit is running (green icon)Blinking icon: Partial alarm(one compressor affected by theexisting alarm) or Alert (no actiontaken on the unit),Steady icon: Alarm(s) active onthe unitLogin screen Parameters screen(s)Login: Confirm advanced access login Save changesLogout: Reset the user level access and go to the splashscreen Cancel your modificationsForce screen (override) Navigation buttonsSet force: Override the current command (if possible) Displayed when the menu includes more than one page:Go to the previous pageRemove force: Remove the forced command Displayed when the menu includes more than one page:Go to the next page9