Recording and Play BackE-311. Press the RECORDER button so the PLAYlamp is lit.2. Use the T/NO and S/YES buttons to displaya song number (1 to 5).NOTE• When a song has something recorded in both tracks, youcan turn off one track and play back just the other track,if you want. Whether a track is on or off is indicated bythe lamps above the TRACK/PART button. Each press ofthe TRACK/PART button cycles through the differentpossible track on/off settings.3. Press the START/STOP button.• This starts playback of the song and/or track youselected.NOTE• You can change the tempo setting as a track is playing.• You cannot change the tone setting during playback.• Press the START/STOP button again to stop playback.IMPORTANT!• The procedure below deletes all of the data of theselected song. Note that the delete operation cannot beundone. Check to make sure you really do not need thedata before you perform the following steps.1. Press the RECORDER button so the PLAYlamp is lit.2. Use the T/NO and S/YES buttons to displaya song number (1 to 5).3. Press the RECORDER button so the REClamp is flashing.4. Use the TRACK/PART button to select thetrack you want to delete.• This will cause the lamp of the selected track to flash.5. Hold down the RECORDER button until “dEL”(delete) appears on the display.6. Press the S/YES button.• This will delete the selected track and enter recordstandby.• To cancel the operation, press the T/NO button inplace of the S/YES button.NOTE• All digital piano operations except for the RECORDERbutton and the T/NO and S/YES buttons are disabledfrom step 5 until the delete operation is executed in step 6of the above procedure.To play back from digital pianomemoryTo delete a specific track