Camera Installation and Mounting7 BNC crimping toolFigure 5: Recommended Tools3.3 Attach the Base Mount to the CameraTo attach the base mount to the camera1. Screw the base mount into the camera body with eight #6 screws.Figure 6: Attaching the Base Mount2. Using the electric screwdriver, tighten the fasteners to about 8 inch-pounds (0.904 newton meters)of torque.3. Using the electric screwdriver and the Torx T10 security bit, tighten the fasteners to about 10 in-lbs.(1.23 newton meters) of torque.3.4 Connecting the Camera CablesIn order to connect the camera to the network, take the analog video cable, network cable, power supplyleads (if an AC or DC supply is used), and alarm, relay, and RS-485 wiring (if used) from the wall at theinstallation site.In order to connect the wires to the connectors on the camera’s connector panel, they must be wiredthrough the supplied cordgrip. Wires must be fed from the wall through the camera’s mounting assembly,through the opening on the underside of the camera, through the camera body, and out of the opening onthe camera’s connector panel. The wires then must be attached to connectors before attaching them to theconnector panel.
