Outdoor Camera Installation103Step 2:Remove the rubber plug from the hole on the cover.Step 3:Thread the connectors of the camera’s system cable one byone through the cover hole.Step 4:Insert the rubber plug back to the cover hole. Use a flatheadscrewdriver to tighten the stainless steel ring by turning theknob clockwise. Make sure there’s no gap between the systemcable and the cover hole.Step 5:Connect the required cables to the connectors of the systemcable through the cover hole (1). Then coat the jointsbetween the connectors and the cables with silicone gel (2).Step 6:Arrange the system cable and replace the Pole MountJunction Box cover. Align the two screw holes of the camerawith the screw holes on the cover. Fasten the camera withthe M4 mechanical screws.
