CB-5222 User and Installation Guide52MJPEG/H.264 Frame Rate Setting The default setting of the MJPEG frame rate is 30 fps in NTSC and 25 fps in PAL. The default setting of the H.264 frame rate is 30 fps in NTSC and 25 fps in PAL The settingrange is from 1 to 30 in NTSC and 1 to 25 in PAL. Settings are: PAL: 1, 5, 13, and 25 fps NTSC: 1, 2, 3, 6, 7.5, 10, 15, and 30 fpsClick SAVE to confirm the settings.AudioFrom the Audio screen you can select the Transmission Mode, Server Gain, and Bit Rate.Figure 53: Audio ScreenTo set the Transmission ModeSelect one of the following options: Full-duplex (Talk and listen simultaneously) – In this mode, the local and remote sitescan communicate with each other simultaneously, i.e. both sites can speak and beheard at the same time. This is the default setting. Half-duplex (Talk or listen, not at the same time) – In this mode, the local or remotesite can only talk or listen to the other site at one time. Simplex (Talk only) – In this mode, the local/remote site can only talk to the other site. Simplex (Listen only) – In this mode, the local/remote site can only listen to the othersite. Disable – Select this option to turn off the audio transmission function.To set the Server GainFrom the Input gain drop-down list, select a setting from 1 to 10 or Mute, which turnsoff the audio. The default setting is 3.From the Output gain drop-down list, select a setting from 1 to 6 or Mute, which turnsoff the audio. The default setting is 3.
