Installation13Tip:A camera setup adapter, such as Veracity Pinpoint, can be used to connect a laptopdirectly to the camera when using PoE.Camera Mounting InstructionsRead the instructions provided in this chapter thoroughly before installing the CB-5222 camera. Thefollowing points are additional considerations: There must be a fuse or circuit breaker at the starting point of the electrical wiringinfrastructure. For indoor installations, such as industrial applications, the CB-5222 camera must beprotected from hostile external elements (e.g., corrosive environment, metallic dust,extreme temperatures, soot, moisture, over spray, etc.) Do not place the CB-5222 camera on or near radiators and heat sources. All electrical work must be performed in accordance with local regulatory requirements.Caution:To avoid damage from overheating or unit failure, assure that there is sufficienttemperature regulation to support the unit’s requirements (cooling/heating). Operatingtemperature should be kept in the range specified for the product with no more than90% relative humidity, non-condensing.Attention:Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vousque la régulation de température est suffisante pour répondre aux exigences de l'unité(refroidissement/chauffage). La température de fonctionnement doit être maintenuedans la plage de température spécifiée pour le produit sans condensation d'humiditésupérieur à 90%.To mount the cameraScrew the camera’s mounting base into the ceiling/wall/flat surface.Set the camera in a fixed position for the Field of View required.Connect the cables and wiring to the camera. See Figure 5: CB-5222 CameraInput/Output Connections.