CB-5222 User and Installation Guide34To enable the SNMP v3 protocol, enter the appropriate data and passwords requested: Enable SNMP v3 – Select the checkbox. Security Name – See note below. Authentication Type – Select MD5 or SHA from the drop-down list. See note below. Authentication Password – See note below. Encryption Type – Select DES or AES from the drop-down list. See note below. Encryption Password – See note below.Note:You may have to consult with your System Administrator to activate this function.Traps for SNMP v1/v2/v3Traps are used by the camera to send messages to a management system for important events orstatus changes. Configure the following settings as required: Enable traps – Check this box to activate trap reporting. Trap address – Enter the IP address of the management server. Trap community – Enter the community to use when sending a trap message to themanagement system. The default value is public. Warm start – Select this checkbox if you want the camera to perform a software reload(warm start SNMP trap).Click SAVE when complete.9.2.1.3.4 UPnPThe UPnP screen enables the Universal Plug-and-Play protocol on your network devices.Figure 28: UPnP Screen
