Installation (for qualified installers only) 53© Travis Industries 6/19/18 - 1418 DaVinci-Cat2+Gas Inlet LocationGas inlet is determined by fireplace configuration and how the fireplace was ordered. Refer to thedimensions pages for the configuration being used to determine what options are available (pages 7through 12). When ordering the fireplace, the gas inlet is either from the side (left or right) or from thebase (left or right).Gas inlet dimensions are shown below. Make sure to refer to the end style being used.Type of Fireplace Type of Ends1-Sided Two Steel EndsSee Through Two Steel EndsPier One Steel, One Glass EndFull Bay Two Glass EndsIsland Two Glass EndsGas Inlet – Steel EndThe gas inlet is on the side (not available from the base).Gas Inlet – Glass EndThe gas inlet is on the side or the base. NOTE: The gas inlet on the base is only available in onelocation. When looking from the side, the gas inlet from the base will always be on the left. Glass End Steel EndThe gas line may berepositioned to the back.1"(25mm)4.5" (115mm) Front4" (102mm)The gas line may berepositioned to the back.1"(25mm)3.125" (80mm) Front3.625" (93mm)Side Inlet2.5" (64mm)The gas inlet is approximately 1/8"(3mm) above the base of the fireplace.Base InletLEFT SIDE - Gas Inlet is 6" (153mm) from the rear edge.RIGHT SIDE - Gas Inlet is 6" (153mm) from the front edge.
