Installation (for qualified installers only) 93© Travis Industries 6/19/18 - 1418 DaVinci-Cat2+Glass Pane Installation and RemovalThis fireplace uses a dual layer of glass to provide combustion air to the fireplace and keep the exteriorcool. The glass panes are packaged separately and do not use a steel glass frame.The appliance must be completely cool before removing the glass.Do not strike or slam the glass.Warning: Do not operate appliance with the glass removed, cracked or broken.Replacement of the glass should be done by a licensed or qualified service person.Use only glass provided by Travis Industries for this appliance. Do not use substituteglass.Suction CupsNOTE: Suction cups are required for glass installation and removal. These are available from TravisIndustries (sku 94400914).When to Install the Glass PanesThe glass is typically installed after all other steps have been completed. This helps ensure the glass iskept clean and away from potential damage.(a) Fireplace should be in location and attached to power, gas, vent and intake.(b) Install the firebacks.(c) Install the inner glass and test-start the fireplace. This is done to verify applianceoperation only. Do not let the appliance burn for more than 5 minutes.(d) Remove the front inner glass.(e) Install the crushed glass over the burner and inner media trays.(f) Replace the front inner glass.(g) On Pier, Bay, and Island models, install the side outer glass panes.(h) If crushed glass is being used in the intake air channel, install it at this time.(i) Install the remaining outer glass panes.Overview of Glass Panes – Category 2 FireplacesType of Fireplace # of Glass Panes Glass Sizing1-Sided 2 TBDPier 6 TBDFull Bay 6 TBDIsland 8 TBD2-Sided 4 TBDCheck for the DaVinci Logo Before Installing the GlassThe outer piece of glass has a DaVinci logo. Make sure it is on the lower right and is facing outwards.
