Air and Water cooled inverter chillers and heat pumpEWAD TZ - EWAD TZ B - EWWD VZAir and Water cooled inverter chillersand heat pumpD-EOMZC00105-17ENOperation Manual19/84The initial screen when the remote is turned on shows the units connected to it. Highlight the desired unit andpress the wheel to access it. The remote will automatically show the units attached to it, no initial entry isrequired.The Remote HMI can be extended up to 700m using the process bus connection available on the UC. With adaisy-chain connection as below, a single HMI can be connected to up to 8 units. Refer to the specific HMImanual for details.3.8 Embedded Web InterfaceThe MicroTech III controller has an embedded web interface that can be used to monitor the unit whenconnected to a local network. It is possible to configure the IP addressing of the MicroTech III as a fixed IP ofDHCP depending on the network configuration.With a common web browser a PC can connect with the unit controller entering the IP address of the controlleror the host name, both visible in the “About Chiller” page accessible without entering a password.When connected, it will be required to enter a user name and a password. Enter the following credential to getaccess to the web interface:User Name: ADMINPassword: SBTAdmin!The Main Menu page will be displayed. The page is a copy of the onboard HMI and follows the same rules interms of access levels and structure. MicroTech® III
