SiEBE18-526 Field Setting for SkyAir Indoor UnitTest Operation 1294.2 Field Setting4.2.1 Wired Remote ControllerNote: (Field setting must be made from the remote controller in accordance with the installationconditions.) Setting can be made by changing the “Mode number”, “FIRST CODE NO.”, and “SECONDCODE NO.”. Refer to the following procedures for Field setting.Procedure When in the normal mode, press the “ ” button for a minimum of four seconds, and the FIELDSET MODE is entered. During group control, when setting by each indoor unit (mode No. 20, 21 and 23 have beenselected), push the “ ” button and select the INDOOR UNIT NO to be set. (This operation isunnecessary when setting by group.) Select the desired MODE NO. with the “ ” button. Push the “ ” button for about one second to return to the NORMAL MODE.(Example) If during group setting and the time to clean air filter is set to FILTER CONTAMINATION -HEAVY, SET MODE NO. to “10,” FIRST CODE NO. to “0,” and SECOND CODE NO. to “02.” Push the “ ” button once and the present settings are SET. Push the “ ” lower button and select the SECOND CODE NO. Push the “ ” upper button and select FIRST CODE NO.UNIT NO. MODE NO.SECONDCODE NO.FIRSTCODE NO.FIELDSETMODE2P068938-1
