Instruction SiEBE18-526194 System Configuration2.2.14 Care and CleaningFTXS20/25/35D, CTXS50DCare and CleaningCAUTION Before cleaning, be sure to stop the operation andturn the breaker OFF.Units Indoor unit, Outdoor unit and Remote control Front panel1. Wipe them with dry soft cloth.1. Open the front panel.2. Remove the front panel.3. Clean the front panel.4. Attach the front panel.• Hold the panel by the tabs on the two sides and liftit unitl it stops with a click.• Lift the front panel up, slide it slightly to theright, and remove it from the horizontal axle .• Wipe it with a soft cloth soaked in water.• Only neutral detergent may be used.• In case of washing the panel with water, dry it withcloth, dry it up in the shade after washing.• Set the 2 keys of the front panel into the slots andpush them in all the way.• Close the front panel slowly and push the panel atthe 3 points.(1 on each side and 1 in the middle.) Fit the keyinto the slot.CAUTION• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.• When removing or attaching the front panel, use a robust and stable stool and watch your steps carefully.• When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.• For cleaning, do not use hot water above 40 °C, benzine, gasoline, thinner, nor other volatile oils,polishing compound, scrubbing brushes, nor other hand stuff.• After cleaning, make sure that the front panel is securely fixed.
