Instruction SiEBE18-526222 System Configuration123Press the AIR FLOW DIRECTION ADJUSTbutton to select the air direction as following.The AIR FLOW FLAP displayswings as shown left and theair flow direction continuouslyvaries. (Automatic swingsetting)swingPress AIR FLOW DIRECTIONADJUST button to select the airdirection of your choice.The AIR FLOW FLAP displaystops swinging and the airflow direction is fixed (Fixedair flow direction setting).MOVEMENT OF THE AIR FLOW FLAPFor the following conditions, micro computercontrols the air flow direction so it may be differentfrom the display.Operationmode HeatingOperationcondition• When starting operation• When room temperature is higherthan the set temperature• At defrost operation(Air is blown horizontally to preventthe cool air from being blowndirectly onto anyone in the room.)Operation mode includes automatic operation.PROGRAM TIMER OPERATIONTIMER MODE START/STOPPress the TIMER MODE START/STOPbutton several times and select themode on the display.The display flashes.For setting the timer stop..... “ ”For setting the timer start .... “ ”Operate in the following order.• The timer is operated in the following two ways.• Programming the stop time ( ) .... Thesystem stopsoperating after the set time haselapsed.• Programming the start time ( ) .... Thesystem startsoperating after the set time haselapsed.• The timer can be programmed a maximum of 72hours.• The start and the stop time can be simulta-neously programmed.PROGRAMMING TIMETIMER ON/OFFPress the PROGRAMMING TIME button andset the time for stopping or starting thesystem.When this button is pressed, the timeadvances by 1 hour.When this button is pressed, the timegoes backward by 1 hour.Press the TIMER ON/OFF button.The timer setting procedure ends.The display “ or ” changes fromflashing light to a constant light.Refer to figure 4 on page [1]NOTE• When setting the timer Off and On at the sametime, repeat the above procedure from 1 to 3once again.When the timer is programmed to stop the systemafter 3 hours and start the system after 4 hours, thesystem will stop after 3 hours and then 1 hour laterthe system will start.• After the timer is programmed, the display showsthe remaining time.• Press the TIMER ON/OFF button once again tocancel programming. The display vanishes.7. OPTIMUM OPERATIONObserve the following precautions to ensure thesystem operates.• Adjust the room temperature properly for acomfortable environment. Avoid excessive heatingor cooling.• Prevent direct sunlight from entering a room duringcooling operation by using curtains or blinds.• Ventilate the room regularly.Using the unit for longperiods of time requires attentive ventilation of theroom.• Do not place items that might be damaged bywater under the indoor unit.Water may condensate and drip if the humidityreaches 80% or if the drain exit gets clogged.• Keep doors and windows closed. If the doors andwindows remain open, room air will flow out andcause to decrease the effect of cooling andheating.
