SiUS331604E MAIN/SUB SettingRemote Controller 243.2 Wireless Remote ControllerIntroductionTo set the wireless remote controller, you have to set the address for: The receiver of the wireless remote controller The wireless remote controller.Setting the Address for the ReceiverThe address for the receiver of the wireless remote controller is factory setting to 1. To change this setting,proceed as follows:Set the wireless address switch (SS2) on the PCB according to the table below.When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller should be set toMAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.Setting the Address for the Wireless Remote ControllerThe address for the wireless remote controller is factory setting to 1. To change this setting, proceed as follows:1. Hold down the button and the button for atleast 4 seconds to get the Field setting mode.(Indicated in the display area in the figure at right.)2. Press the button and select a multiple setting (A/b).Each time the button is pressed the display switches between Aand b.3. Press the button or button to set the address.Address can be set from 1 to 6, but set it to 1 ~ 3 and to sameaddress as the receiver. (The receiver does not work withaddress 4 ~ 6.)4. Press the button to enter the setting.5. Hold down the button for at least 1 second to quit theField setting mode and return to the normal display.Unit No. No. 1 No. 2 No. 3Wireless addressswitch (SS2)MAIN/SUB MAIN SUBMAIN/SUBswitch (SS1)1 2 31 2 31 2 3SMSMMode 3241Address5Multiplesetting1 2 3 4 5 6
