Danfoss FC 300 Design Manual

Also see for FC 300: Operating instructions Instruction manual Design guide Design guide Design guide

Contents

Danfoss FC 300 Design Manual Manual pdf 153 page image

Illustration 8.5: Mains connection size C3 (IP20). Illustration 8.6: Mains connection size C4 (IP20).Usually the power cables for mains are unshielded cables.8.1.3 Motor ConnectionNB!Motor cable must be screened/armoured. If an unscreened/unarmoured cable is used, some EMC requirements are not complied with.Use a screened/armoured motor cable to comply with EMC emission specifications. For more information, seeEMC Test Results.See section General Specifications for correct dimensioning of motor cable cross-section and length.Screening of cables: Avoid installation with twisted screen ends (pigtails). They spoil the screening effect at higher frequencies. If it is necessary tobreak the screen to install a motor isolator or motor contactor, the screen must be continued at the lowest possible HF impedance.Connect the motor cable screen to both the decoupling plate of the frequency converter and to the metal housing of the motor.Make the screen connections with the largest possible surface area (cable clamp). This is done by using the supplied installation devices in the frequencyconverter.If it is necessary to split the screen to install a motor isolator or motor relay, the screen must be continued with the lowest possible HF impedance.Cable-length and cross-section: The frequency converter has been tested with a given length of cable and a given cross-section of that cable. If thecross-section is increased, the cable capacitance - and thus the leakage current - may increase, and the cable length must be reduced correspondingly.Keep the motor cable as short as possible to reduce the noise level and leakage currents.Switching frequency: When frequency converters are used together with Sine-wave filters to reduce the acoustic noise from a motor, the switchingfrequency must be set according to the Sine-wave filter instruction in par. 14-01Switching Frequency.1. Fasten decoupling plate to the bottom of the frequency converter with screws and washers from the accessory bag.2. Attach motor cable to terminals 96 (U), 97 (V), 98 (W).3. Connect to earth connection (terminal 99) on decoupling plate with screws from the accessory bag.4. Insert plug connectors 96 (U), 97 (V), 98 (W) (up to 7.5 kW) and motor cable to terminals labelled MOTOR.5. Fasten screened cable to decoupling plate with screws and washers from the accessory bag.All types of three-phase asynchronous standard motors can be connected to the frequency converter. Normally, small motors are star-connected (230/400V, Y). Large motors are normally delta-connected (400/690 V, Δ). Refer to the motor name plate for correct connection mode and voltage.FC 300 Design Guide 8 Electrical InstallationMG.33.BC.02 - VLT® is a registered Danfoss trademark 1538