8 Appendix8.1 Parameter ListsThe parameters are determined by parameter numbers. Werecommend using the alphabetical overview as a guide;then you will be able to find detailed information veryquickly using the number or the link.Changes during operation“TRUE” means that the parameter can be changed, whilethe frequency converter is in operation.“FALSE” means that the frequency converter must bestopped before a change can be made.4-Set-up“1-Set-up”: Data value will be the same in all set-ups.Conversion indexThis number refers to a conversion figure used whenwriting or reading by means of a frequency converter.Please see for all conversion indices the VLTAutomationDrive Design Guide, MG.33.BX.YY.Conversion index 0Conversion factor 1Data typePlease see for all data types the VLT AutomationDriveDesign Guide, MG.33.BX.YY.Data type Description Type2 Integer 8 Int83 Integer 16 Int164 Integer 32 Int325 Unsigned 8 Uint86 Unsigned 16 Uint167 Unsigned 32 Uint328.1.1 Application Parameters, Parameter Group 19-**Par. No. # ParameternameParameter description Default setting Changesduringoperation4-set-up ConversionindexType19-0* Application Parameters19-00 Application parameters 0 'TRUE'… TRUE19-89 Application parameters 0 TRUE19-9* Read-only Application Parameters19-90 Application parameter 90 0 read only 1 set-up 0 Int3219-91 Application parameter 91 0 read only 1 set-up 0 Int3219-92 Application parameter 92 0 read only 1 set-up 0 Int3219-93 Application parameter 93 0 read only 1 set-up 0 Int3219-94 Application parameter 94 0 read only 1 set-up 0 Int3219-95 Application parameter 95 0 read only 1 set-up 0 Int3219-96 Application parameter 96 0 read only 1 set-up 0 Int3219-97 Application parameter 97 0 read only 1 set-up 0 Int3219-98 Application parameter 98 0 read only 1 set-up 0 Int3219-99 Application parameter 99 0 read only 1 set-up 0 Int32Appendix MCO 305 Operating InstructionsMG.33.K3.02 - VLT® is a registered Danfoss trademark 358 8